Consistency Case study

Centre console trim, 12 cavities, 8 minutes a shot

A carbon fibre centre console trim is judged by how it looks in the car, not by a coupon. This one runs on HP-RTM at twelve cavities, eight minutes a cycle, and the visible face comes out of the tool.

Constraint

The customer supplied a drawing: the outer face of a centre console trim has to be the carbon weave itself — the same weave, the same gloss, part after part — at 40,000 a year. Hand finishing at that rate is not a plan. The surface has to come out of the tool.

Carbon-fibre automotive centre console trim being loaded into a container
Packing and loading, not the part — the customer and the geometry stay under NDA.

Solution

HP-RTM. A dry preform is loaded into a 12-cavity tool, resin is injected under pressure, and the part cures in the mould. The visible face is formed against the polished tool surface, so the weave and the gloss are set by the tool rather than by a finisher.

Result

300 g a part; 12 cavities on an 8-minute cycle, 90 parts an hour; a 30-day tool. The year's 40,000 parts ran in 23 days. Part geometry and the customer name are withheld under NDA; the photograph shows the packing, not the part.

Parts outside the standard catalogue are made to drawing, on the same tooling and inspection route. Send the drawing and you get a route, a tolerance and a lead time.

Which product this part maps to

Send the drawing. We will send the route.

A drawing, a photo of a failed part, or three lines of requirement is enough to start. Scope, price indication and lead time within 24 hours.

No commitment · NDA available · Reply within 24 hours

Request a quote WhatsApp