Home Products

Carbon and glass fibre sections

Carbon and glass fibre sections, made by pultrusion, roll wrapping and compression moulding. This page is the way into four families — tube, plate, rod and profile — and into the choice underneath them: which form, and which process, for a given load case.

Hexagonal carbon fibre tube

TubesCarbon fibre

Across flats 10–100 mm (hexagon and octagon), wall 1.0–10 mm (matched to A/F)

Pultrusion / roll wrapping / compression moulding

Tapered tube

TubesCarbon fibre

Large end 12–150 mm, small end 8–90 mm, taper 1:300 to 1:15

Roll wrapping / filament winding / compression moulding

GRP tube

TubesGlass fibre

Stock range: outside diameter 4–150 mm, wall 1–6 mm

Pultrusion as standard, winding for large diameters, roll wrapping for thin-wall small batches

Rigid carbon fibre sheet

PlatesCarbon fibre

Thickness 0.3–50 mm; full sheet 2440×1220 mm (4×8 ft)

Compression moulding (continuous fibre) / (chopped, forged finish); pultruded UD to drawing

Carbon fibre honeycomb sandwich panel

PlatesCarbon fibre

Overall thickness 6–30 mm; skin 0.5–1.5 mm (0.75 mm minimum below 8 mm overall); core 4–27 mm

Adhesive-film hot pressing, vacuum bagging, WCM wet compression moulding

Fibreglass sheet

PlatesGlass fibre

Thickness 0.5–50 mm; full sheet 1220×2440 mm or 1020×1220 mm

Hot-pressed lamination; continuous lamination for thin sheet, compression moulding for thick

GRP rod

RodsGlass fibre

Ø3–150 mm standard, larger to drawing

Pultrusion; ground on request

Carbon fibre flat bar

ProfilesCarbon fibre

Width 5–50 mm, thickness 0.5–10 mm, section 2.5–500 mm² (width-to-thickness 2:1–100:1; outside that, square bar or sheet)

Pultrusion, unidirectional 0°

Carbon fibre angle

ProfilesCarbon fibre

Equal leg 10×10–100×100 mm (80 and above made to drawing), wall 1–10 mm

Pultrusion

Carbon fibre channel

ProfilesCarbon fibre

Channel depth 20–150 mm, flange width 10–75 mm, wall thickness 1.5–6 mm

Pultrusion

Carbon fibre I beam

ProfilesCarbon fibre

Section depth 30–200 mm, flange width 20–120 mm, wall thickness 2.5–8 mm

Pultrusion

Carbon fibre T profile

ProfilesCarbon fibre

Section depth 20–150 mm, flange width 20–100 mm, wall thickness 2–6 mm

Pultrusion

GRP angle

ProfilesGlass fibre

Equal leg 25–150 mm, wall 3–12 mm; unequal leg to drawing

Pultrusion

GRP channel

ProfilesGlass fibre

Height 50–200 mm, width 25–75 mm, wall 3–12 mm

Pultrusion

GRP I beam

ProfilesGlass fibre

Depth 60–300 mm, flange 30–150 mm, wall 4–12 mm

Pultrusion

Not in the list?

Made to drawing

Send the drawing or the duty — we will say whether it can be made, and how.

Talk to us

Send the drawing. We will send the route.

A drawing, a photo of a failed part, or three lines of requirement is enough to start. Scope, price indication and lead time within 24 hours.

No commitment · NDA available · Reply within 24 hours

Request a quote WhatsApp